Straight Couplings Q CTS x Q CTS
SAME CONNECTIONS ON BOTH ENDS - NO INTERNAL PIPE STOP ON STRAIGHT SIZES
A.Y. McDonald Service Fittings are manufactured to meet or exceed the AWWA C800 (latest revision) standard. Our service fittings are
rated to withstand the same pressures as the tubing they are designed to fit. They are designed and tested for cold potable water only.
EPDM rubber gaskets are used in our Compression fittings.
RANGER will fit on the following types of pipes:
- CTS – Copper Tube Type K or L - CTS – Polyethylene ASTM D2737 SDR 9 Tube Size
- CTS – PEX Tubing ASTM F876 SDR 9 CSA B137.5 - CTS – Polybutylene ASTM D2666 SDR 9 Tube Size Class 250
- PEP – Polybutylene ASTM D2662 SIDR7
- PEP – Polyethylene ASTM D2239 SIDR7
- PEP – Polyethylene ASTM D2239 SIDR9 Polyethylene Pipe Size
- PVC – PVC ASTM D1785 SCH. 40
- IPS – Polyethylene ASTM D3035 SDR 9 / SDR 11 OD Controlled Iron Pipe Size
- IP – Steel Pipe
The RANGER is designed with a 301 stainless steel grip ring, a brass friction ring, and an EPDM rubber gasket.
Features:
- Manufactured in the United States
- No-Lead C89833, NSF/ANSI/CAN/61-2018, NSF/ANSI 372-2016
- Meet and exceeds AWWA C800-14, which requires fittings to be suitable for a water pressure of 150 PSIG
- Withstands the same pressures as the tubing, but must not be used with pressures exceeding 300 PSIG
- Double Leed Thread allows for compression nut to be assembled in half the time of a standard compression nut
and eliminates the possibility of assembling an incompatible nut to these fittings.
- Designed for underground and aboveground cold potable water systems
- Large wrench flats for tightening to torque
- Tighten-to-torque required - noted on installation instructions
- Provides pull-out strength equal to other compression fittings
Insert stiffeners are required on all flexible plastic connections.
Submittal Sheet