1in x 3/4in
Underground Utility Supplies
View:
Active Filters :
- Main Category: Underground Utility Supplies
- Size: 1in x 3/4in 10in x 8in
Part #:130-5140-121
- Y-Branches -22 CTS x -22 CTS (708Y) Y-Branch Asmbly (S) Service Ftg (2) CTS (2) CTS
A.Y. McDonald Service Fittings are manufactured to meet or exceed the AWWA C800 (latest revision) standard. Our service fittings arerated to withstand the same pressures as the tubing they are designed to fit. They are designed and tested for cold potable water only.EPDM rubber gaskets are used in our Compression fittings.
Qty:
Part #:204351
- Description SDR35 Gasketed Fittings 10x8 TEE GxGxG
Qty:
Part #:204112
- Description SDR35 Gasketed Fittings 10x8 WYE GxGxG
Qty:
Part #:204942
- 622 Tapping Sleeve, Fabricated Steel, Neck Seal - For tapping size-on-size or reducing branch connections on new or existing pipe
Description Tapping sleeve.Application For 4" pipe and larger reducing and size-on-size flanged outlets. Available with ¾"-6"threaded outlets.Key Features
&bullEasy to install&bullHas range to reduce inventory
&bullMeets AWWA C223 Standards&bullEpoxy Finish meets AWWA C213 Standards
&bullVirtually 360º support of the pipe
&bullRoll-resistant gasket will not bind
&bullGasket seal increases with line pressure
&bullNo special tools required to install the sleeve
&bullFlanged outlets are recessed to accept tapping valves
&bullFlexi-Coat® Fusion-Bonded Epoxy Finish is standard for superior corrosion resistance
&bull¾" test outlet to allow hydrostatic pressure test before tapping the pipe (not available in standard 4" x 4")
Qty:
Qty:
Part #:200255
- Brass Bushings AWWA x AWWA Bushing
A.Y. McDonald brass bushings are designed and used to change the thread of the inlet of a Corporation Stop or tap of a Saddle. Bushingsinclude a generous size wrench flat for ease of installation and lay length for the appropriate thread size.
Qty:
Part #:130-5141-144
- Straight Adaptors -22 CTS x MNPT ONE END MALE NATIONAL PIPE THREAD
A.Y. McDonald Service Fittings are manufactured to meet or exceed the AWWA C800 (latest revision) standard. Our service fittings arerated to withstand the same pressures as the tubing they are designed to fit. They are designed and tested for cold potable water only.EPDM rubber gaskets are used in our Compression fittings.
Qty:
Part #:130-4137-296
- Meter Coupling &ndash 10J34B Female Meter Thread x Male Meter Thread
Manufactured in compliance with ANSI/AWWA C800 (latest revision)Brass components conform to UNS C36000
$
26.80
Qty:
Displaying: 1 - 8 of 8 Matching Items