3/4in x 1in
Underground Utility Supplies
View:
Active Filters :
- Main Category: Underground Utility Supplies
- Size: 3/4in x 1in 5/8in 12in x 8in
Part #:204567
- Straight Couplings SAME CONNECTIONS ON BOTH ENDS - NO INTERNAL PIPE STOP ON STRAIGHT SIZES -22 CTS x -22 CTS
A.Y. McDonald Service Fittings are manufactured to meet or exceed the AWWA C800 (latest revision) standard. Our service fittings arerated to withstand the same pressures as the tubing they are designed to fit. They are designed and tested for cold potable water only.EPDM rubber gaskets are used in our Compression fittings.
Qty:
Qty:
Part #:205235
-
663 Tapping Sleeve, Stainless Steel, Finger Lug Style, Full Gasket - For tapping size-on-size or reducing branch connections on new or existing pipe
Description All stainless steel tapping sleeve with 360º gasket seal.Application For tapping size-on-size or reducing branch connections on new or existing pipe.Key Features&bull Easy to install&bull Range helps reduce inventory&bull Meets applicable AWWA C223 Standards&bull Molded-in ring in the gasket to ensure effective sealing&bull Nylon washers provided to improve bolt torque capability&bull Heavy gauge, all-Stainless Steel body for rugged performance&bull Fully chemically passivated for maximum corrosion protection&bull ¾" test outlet to allow hydrostatic pressure test before tapping the pipe&bull 360º seal provides maximum support and reinforcement around the pipe in case of pipe break&bull Body drawn out to accept the outlet neck adding to the overall strength of the area under the most stress
$
1,841.06
Qty:
Part #:200431
- SUBMITTAL INFORMATION • Manufactured in compliance with ANSI/AWWA C800 (latest revision)• Brass components in contact with potable water conform to ASTM B584, UNS C89833 (latestrevision) and identified with “NL”• Certified to NSF/ANSI 61 and NSF/ANSI 372• Brass components not in contact with potable water conform to ASTM B62 and ASTM B584, UNSC83600 -85-5-5-5 (latest revision)• Large wrench area provided for proper installation:
$
23.05
Qty:
Part #:204702
- Tees SAME END CONNECTIONS ON ALL THREE SIDES -22 CTS x -22 CTS x -22 CTS
A.Y. McDonald Service Fittings are manufactured to meet or exceed the AWWA C800 (latest revision) standard. Our service fittings arerated to withstand the same pressures as the tubing they are designed to fit. They are designed and tested for cold potable water only.EPDM rubber gaskets are used in our Compression fittings.
Qty:
Part #:130-5139-000
- Straight Ball Valves - Compression x FIP 90º ON/OFF TEE OPERATING HEAD, T CTS x FNPT
A.Y. McDonald Ball Curb Stops maintain a low turning torque and bubble-tight 300 PSIG water pressure rating due to the PTFE coated brassball that is supported by two blow-out proof EPDM seals. The end piece joint is sealed with an EPDM O-ring and thread locker. McDonaldBall Curb Stops offer positive shut-off from either direction and are available with a wide variety of end connections.
$
182.85
Qty:
Displaying: 1 - 6 of 6 Matching Items