16in
2-7/16in
Qty:
Qty:
Part #:503696
- 1/4" Shank Diameter Eyebolts Shoulder Pattern
Forged from the best quality carbon steel, hardened and tempered to ensure increased strength and toughness and reduce liability or breakage
Each lot is tested and inspected to insure conformance to specifications
Available with UNC Class 2A thread only
Eyebolt shanks should never be undercut or eyebolt shank diameters reduced
Shoulder eye bolts must be properly seated (should bear firmly against the mating part) otherwise the working loads must be reduced substantially. A steel washer or spacer may be required for proper seating
To obtain greatest strength from an eye bolt, it must fit reasonably tight in the hole into which it is screwed to prevent unscrewing due to twist of cable. Tightness and seating must be checked after initial load
Qty:
Qty:
Part #:503205
- Spline Bit 2-Cutter 1/2" x 16"
Milwaukee®'s Spline 2-Cutter Rotary Hammer drill bits are used for drilling intro brick, block, and concrete
Qty:
Part #:500551
- 3/4" Drive Extensions
&bull Chrome plating provides increased protection from rust and corrosion
&bull Ball and spring socket retention
Qty:
Qty:
Qty:
Qty:
Part #:503254
- Spline Bit 2-Cutter 1-1/8" x 16"
Milwaukee®'s Spline 2-Cutter Rotary Hammer drill bits are used for drilling intro brick, block, and concrete
Qty:
Part #:503256
- Spline Bit 2-Cutter 1-1/4" x 16"
Qty:
Qty:
Qty:
Part #:501513
- Country of Origin US:
Qty:
Qty:
Part #:503210
- Spline Bit 2-Cutter 5/8" x 16"
Milwaukee®'s Spline 2-Cutter Rotary Hammer drill bits are used for drilling intro brick, block, and concrete
Qty:
Part #:503234
- Spline Bit 2-Cutter 1" x 16"
Milwaukee®'s Spline 2-Cutter Rotary Hammer drill bits are used for drilling intro brick, block, and concrete
Qty:
Qty:
Part #:503914
- 1" Drive Extension 16"
&bull Chrome plating provides increased protection from rust and corrosion
&bull Ball and spring socket retention
&bull Hole in wall of drive end accommodates plunger for firm tool retention
Qty:
Part #:503590
- 16" Long Taper Punches
Designed for aligning the holes in metal pieces through which rivets, bolts, or screws will be inserted
Not intended for driving pins as punch may become stuck in work
Also called line-up aligning or drift punches
Qty:
Part #:501707
- 16" Heavy Duty Pinch Bars
Used for aligning, prying and positioning
Qty:
closeout
Qty:
Qty:
Displaying: 1 - 24 of 26 Matching Items