1-1/8"
7-1/2in
Part #:200391
- 226 Full Circle Clamp DI Lug Single Band - For repairing complete breaks, splits, holes in pipe or joining pipe
Description These clamps provide fast, economical means for repairing full circumferential breaks,holes, cracks and other types of damage.Application Works on Cast Iron, Ductile Iron, Steel, Asbestos Cement, Copper, Aluminum, PVC, HDPE,Fiberglass and other pipe types.Key Features
&bullStainless Steel bands&bullWorking pressure up to 300 PSI
&bullNominal temperature range -20°F to 180°F
&bullRemovable lugs to allow installation in tight spaces
&bullMay be used to join plain end pipe of the same diameter
&bullStandard widths through 30"
&bull360° gasket seal&bullFlexi-Coat® Epoxy Finish for corrosion resistance
&bullRange up to .40" in single band
&bullDrop-in bolts for easier installation
Qty:
Part #:200222
- 226 Full Circle Clamp DI Lug Single Band - For repairing complete breaks, splits, holes in pipe or joining pipe
Description These clamps provide fast, economical means for repairing full circumferential breaks,holes, cracks and other types of damage.Application Works on Cast Iron, Ductile Iron, Steel, Asbestos Cement, Copper, Aluminum, PVC, HDPE,Fiberglass and other pipe types.Key Features
&bullStainless Steel bands&bullWorking pressure up to 300 PSI
&bullNominal temperature range -20°F to 180°F
&bullRemovable lugs to allow installation in tight spaces
&bullMay be used to join plain end pipe of the same diameter
&bullStandard widths through 30"
&bull360° gasket seal&bullFlexi-Coat® Epoxy Finish for corrosion resistance
&bullRange up to .40" in single band
&bullDrop-in bolts for easier installation
Qty:
Part #:509572
- 1-1/8" Shank Diameter Eyebolts Shoulder Pattern
Forged from the best quality carbon steel, hardened and tempered to ensure increased strength and toughness and reduce liability or breakage
Each lot is tested and inspected to insure conformance to specifications
Available with UNC Class 2A thread only
Eyebolt shanks should never be undercut or eyebolt shank diameters reduced
Shoulder eye bolts must be properly seated (should bear firmly against the mating part) otherwise the working loads must be reduced substantially. A steel washer or spacer may be required for proper seating
To obtain greatest strength from an eye bolt, it must fit reasonably tight in the hole into which it is screwed to prevent unscrewing due to twist of cable. Tightness and seating must be checked after initial load
Qty:
Displaying: 1 - 3 of 3 Matching Items