Fluid Film
Lubricants and Paints
View:
Active Filters :
- Main Category: Lubricants and Paints
- Brand: Fluid Film
Part #:1540-FLUIAS11
- Fluid Film Rust & Corrosion Protector - 11.75oz
FLUID FILM Liquid A is an anti-corrosive coating, lubricant and penetrant for all metals. It provides protection against attack by moisture and salt solutions, and may be applied to soften and remove heavy rust. It is excellent for storage or shipment of metals and equipment, and is used in the maintenance of aircraft, heavy machinery, marine equipment (such as rudders, voids, inaccessible areas), mining equipment, farm machinery and automobiles. It is also used in refineries, salt plants, power plants, and gas companies.
Where fluid (soft coating) barrier is not objectionable LIQUID A will protect liquid fertilizer tanks, bulk storage tanks, hoppers, spreaders, collection tanks, sprayers, liquid applicators, combines, mixing plant machinery, sorting machinery, conveyors, elevators and vehicles. LIQUID A will protect the interior of pumps by pouring into intake and turning pump over once or twice to make sure liquid is coating. LIQUID A stops the rust, inhibits the corrosive properties of fertilizers, lubricates all moving parts and displaces moisture.
Specific Gravity
0.903 - 0.913 (77°F)
Viscosity Ford Cup No. 4
30 to 45 seconds, 70°F
Flash Point ASTM-D92 Cleveland Open Cup
157°C (315°F)
VOC. CARB 310
<1%
Specific Conductivity
Less than 10-9 mho/cm @ 1M Hz
Effect on Rubber ASTM D-471 @ ± 158°F 70 hours
None on neoprene and buna-n. May cause swelling on non oil-resistant rubber goods.
Effect on Aluminum
No pitting.
Effect on Copper, Brass
No staining.
Toxicity (Tests peformed by outside laboratory using standard methods)
Oral LD50 greater than 3 g/kilogram. Skin Irritation Non-irritating response. Albino rabbits - 24 hr contact of LIQUID A on intact and abraded skin. Eye Irritation Very slight response. LIQUID A inserted in rabbit's eyes. On immediate washout, slight response after 24 hours. None after 48 hours. With no washout, slight response after 24 hours. None after 72 hours.
Dielectric Strength ASTM-D-877
32.0
Note 1 When welding in tanks coated with LIQUID A, wipe material back a distance of 1.5 meters (5 feet) from where hot work is to be performed and from the deck area beneath the hot work. See Technical Bulletin No. 202.2.
Note 2 Since LIQUID A forms a gel in the presence of water, keep all containers closed tightly when not in use. If LIQUID A thickens in the container, agitation will temporarily return it to a more liquid condition. Thickening does not impair its effectiveness in any way.
Note 3 LIQUID A is not recommended for use in tanks carrying petroleum solvents, acids, ammonia or ammonium hydroxide. Solution of ammonium salts may cause slow degradation of the coating.
Note 4 Shelf life &ndash indefinite.
All components of FLUID FILM® LIQUID A are listed on the TSCA Inventory.
KEEP OUT OF REACH OF CHILDREN. This document is subject to revision without notice.
Qty:
Displaying: 1 - 1 of 1 Matching Items